The combination shoe box and rack shown in Figs. 8 and 9 provides a handy place for Shoes in everyday use and allows less frequently needed footwear to be stored in a dust proof container.

To estimate the inside length of the box, multiply the number of pairs of shoes by 9 in.; the other dimensions are as shown in Fig. 9. Although it is most practical to have a back and bottom, they may be left out and the box ends fastened to the wall and the bottom of the closet.

Fig. 8. - The rack on top provides a place for everyday shoes; the box beneath, for those used less often.

Fig. 9. - End view of the shoe holder shown in Fig. 8. The length depends on the number of shoes.

In making the end pieces, care should be taken that the grain runs vertically. These ends can be made in two pieces, held together with cleats on the inside. If no floor board is used, the thickness of ½ in. should be added to the height of the end pieces.

Fasten the ends, back, and front together so that the ends are inclosed by the front but inclose the back, allowance being made for the 'floor and baseboard moldings. The top and bottom next can be put in place, after the top has been beveled to accommodate the lid. The butt hinges for the lid should be spaced about 12 in. apart.

The rack should be thoroughly sandpapered. For a finish any good penetrating wood stain or dye of the desired color may be used, followed by several coats of shellac, varnish, or clear brushing lacquer.